GE JBS03 Owner's Manual page 29

Cleaning the g/ass cooktop.
GEAppliances.com
Cleon your cooktop after
each spill. Use CERAMA
BRYTE ® Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLY use CERAMA BRYTE ® Ceramic Cooktop
Cleaner on the glass cooktop. Other creams
may not be as effective.
To maintain and protect the surface of your
glass cooktop, follow these steps:
Before using the cooktop for the first
time, clean it with CERAMA BRYTE ®
Ceramic Cooktop Cleaner. This helps
protect the top and makes cleanup
easier.
[]
Daily use ofCERAHA BRYTE ® Ceramic
Cool<top Cleaner will help keep the
cooktop looking new.
Shake the cleaning cream well. Apply a
few drops of CERAMA BRYTE ® Ceramic
Caoktop Cleaner directly to the cooktop.
Use a paper towel or CERAMA BRYTE ®
Cleaning Pad for Ceramic Cooktops to
clean the entire cooktop surface.
Use a dry cloth or paper towel to
remove all cleaning residue. No need
to rinse.
NOTE: It is very important that you DO NOT
heat the cooktap until it has been cleaned
thoroughly.
Use a CERAMA BRYTE ~ Cleaning Pad
for Ceramic Cooktops.
Burned-On Residue
A WARNING:
DAMAGE to your
glass surface may occur if you use scrub
pads other than those recommended.
[] Allow the cooktop to cool.
[] Spread o few drops of CERAHA BRYTE ®
Ceramic Cooktop Cleaner on the entire
burned residue area.
Using the included CERAMA BRYTE ®
Cleaning Pad for Ceramic Cooktops, rub
the residue area, applying pressure as
needed.
If any residue remains, repeat
the steps listed above as needed.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAMA BRYTE ®
Ceramic Cool<top Cleaner and a paper
towel.
The CERAMA BRYTE ® Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE: Do not use a dull or nicked
blade.
Heavy, Burned-On Residue
Allow the cooktop to coot.
Use a single-edge razor blade scraper
at approximately a 45 ° angle against
the glass surface and scrape the soil.
It will be necessary to apply pressure
to the razor scraper in order to
remove the residue.
After scraping with the razor scraper,
spread a few drops of CERAMA BRYTE ®
Ceramic Cool<top Cleaner on the entire
burned residue area. Use the CERAMA
BRYTE ® Cleaning Pad to remove any
remaining residue.
For additional protection, after all
residue has been removed, polish the
entire surface with CERAIvlA BRYTE ®
Ceramic Cooktop Cleaner and a paper
towel.
29
O"