Fg7X Ii Housing's White O-Ring; Installing The Camera - Fantasea Line FG7X II Housing Instruction Manual

8. The white O-ring featured on the backside of the front door should be visually inspected
prior to each dive. If there is any debris present, gently wipe the area with a soft microfiber
cloth in order to cleanse it.

FG7X II Housing's White O-Ring

The white compression O-ring is located on the perimeter of the black housing.
Please note that the white O-ring is not symmetrical and should be inserted with its rounded edge
facing inward (into its seat) and its pointed
edge facing outward or it may affect housing
functionality. See illustration. Attention: Please
note that this O-ring does not need to be
removed or replaced unless it is visibly
damaged. For regular O-ring maintenance, just
wipe its surface with a moist cloth while it is
installed in place.

INSTALLING THE CAMERA

Since the FG7X II Housing is specifically designed for the Canon G7 X Mark II digital camera, installing the
camera in the housing is quite simple.
1. Make sure the camera is turned off.
2. Make sure the housing Flash Up Switch is rotated all the way counterclockwise (pushed
the front of the housing). Failing to do so with interfere with camera installation inside the
housing.
3. Hold the camera parallel to the housing and then gently install it inside (Image #9). Avoid inserting
one side of the camera prior to the other, as this will make the installation difficult and might
cause damage to the camera or housing.
4. Take special care not to touch or damage the Moisture Sensor or Alarm when installing the
camera. The Sensor is located on the bottom of the housing below where the camera would be
positioned and the Alarm is located inside the housing on the inner (right) side of the housing
(Image #10).
towards
17
FG7X II Housing Instruction Manual 20160808
MOISTURE Alarm
5. It is recommended that you insert a silica gel pack inside the housing (the left side of the camera
in the slot midway between the two rubber shock absorber mounts or between the bottom of the
camera and the housing are a convenient locations) in order to prevent moisture accumulation in
the housing. It is important to make sure that the silica gel pack doesn't touch or interfere with
the watertight seals of the housing.
Image #9
Image #10
18
FG7X II Housing Instruction Manual 20160808