Silencing The Alarm; Replacing Batteries - Fantasea Line FG7X II Housing Instruction Manual

SILENCING THE ALARM

1. To silence the Alarm, gently wipe the Sensor unit at the bottom of the housing with a soft dry cloth
until the Sensor is dry and the Alarm is silenced.
2. If drying the Sensor fails to silence the Alarm then remove the Alarm unit from the housing by gently
sliding it out of its slot (Image #27).
3. Expose the white electrical connector [change wording in the image above] under the black tape
wrap (Image #28).
4. Gently pull on the white connector (do not pull by the wires) until the connector parts are
separated. Wait a few minutes before re-connecting. If the Alarm still beeps then separate the
connector again and leave it disconnected for a few hours to ensure that the Sensor is totally dry
and the Alarm has sufficient time to properly reset. Should the Alarm continue then you probably
need a new Alarm module and should contact Fantasea to obtain a replacement.

REPLACING BATTERIES

1. Remove the Alarm unit from the housing by gently sliding it out
of its slot (Image #27).
2. Disconnect the electrical wires connector as previously
described from the unit (Image #28).
Image #27
31
FG7X II Housing Instruction Manual 20160808
3. Peel the black tape wrapped around the Alarm unit by gently cutting it with a sharp blade or utility
knife (Image #29). Make sure that the knife doesn't come in contact with the unit under the tape
and that you only cut the tape. You can also feel for
the battery's location and using a small utility knife or
razor blade simply cut a flap around the battery.
Using this method will give you access to the battery
plus will make it easier to reseal the Alarm unit after
the battery has been replaced.
4. Remove the old battery by lifting it with a small
screwdriver through the battery removal groove
(Image #30).
Install a new 3V Lithium #CR1220 battery,
available at retail stores, watch repair shops or online through services such as
Amazon.
Alarm unit. Using any other type of batteries will cause irreparable damage to the
electrical unit.
5. IMPORTANT! The battery should be installed with the "+" symbol facing up!
6. Gently push the new battery it into the battery compartment and make sure it doesn't fall off
easily.
8. To secure the battery and make sure it doesn't fall out of place, wrap the battery compartment
area with a small piece of electrical tape. Be careful not to cover the round cylinder that produces
the alarm sound. Alternatively, you can wrap the whole alarm unit with tape and then make a hole
over the alarm cylinder (Image #31).
Image #28
9. Insert the electrical wires plug back into the alarm unit socket.
10. Slide the alarm unit back into the dedicated slot inside the housing, opposite the buckle. Make sure
to install the unit with the round alarm cylinder facing the housing interior and the LED pointing
outwards, to the back of the housing (image #32).
Image #29
WARNING:
Install only 3V Lithium #CR1220 batteries inside the Moisture
32
Image #30
FG7X II Housing Instruction Manual 20160808