Replacing The Alarm Unit - Fantasea Line FG7X II Housing Instruction Manual

Image #31
11. You can test the Moisture Detector by placing a wet finger over the Sensor at the bottom of the
housing. Once you have confirmed that the alarm is working, gently dry off the Sensor unit. This
should silence the alarm.

REPLACING THE ALARM UNIT

1. Remove the alarm unit from the housing by gently sliding it out of its slot (Image #27).
2. Expose the white electrical connector under the black tape wrap (Image #30).
3. Disconnect the electrical wires connector from the Alarm unit socket.
4. Connect the electrical wires plug to the socket of a new Alarm unit.
5. Slide the Alarm unit back into the dedicated slot inside the housing, opposite the buckle. Make sure
to install the Alarm unit with the round alarm cylinder facing the housing interior and the LED
pointing outward, toward the back of the housing (Image #32).
6. You can test the Moisture Sensor by placing a wet finger over the moisture sensor unit at the
bottom of the housing. Once you have confirmed that the alarm is working, gently dry off the
moisture sensor unit. This should silence the alarm.
For further information, please visit our website
or contact us at
Image #32
www.fantasea.com
info@fantasea.com
33
FG7X II Housing Instruction Manual 20160808