D-Link DNS-320 Quick Installation Manual page 6

5. Connect an Ethernet cable to the
available Ethernet port. This cable
should connect the ShareCenter
Pulse to your local network via a
router or switch, or directly to a
computer for configuration.
Make sure to align the drive connector to the SATA connector on the bottom
edge inside the drive bay of the ShareCenter Pulse. Gently push the drive in
until it connects. When a drive is inserted properly, you will feel it "seat" into
the connector. Some hard drives that are thin or oddly shaped may need to be
guided carefully into position. If a drive is not properly seated, the light will not
illuminate after powering on the device.
6
6. Connect the power adapter to the
power socket.
DnS-320