Montarbo MT200A Instruction Manual page 14

MT200A
processor controlled active speaker system
Important !
Product care and maintenance:
• Do not expose the enclosure to heat sources
(lamps, lights, high power light sources, radiators
or other products that produce heat).
• Never expose the enclosure to direct sunlight,
excessive vibrations or mechanical shocks.
• Avoid operating and storing the enclosure in
damp or dusty places: this will avoid malfunctions and
premature degrading of specifications.
• Avoid using the enclosure close to strong sources of
electromagnetic interferences (e.g. video monitors, high
power electrical cabling). This may lead to degradation
of audio quality.
• Care should be taken so that objects do not fall and
liquid are not spilled into the enclosure. In public event
don't let people, musicians, technicians or anyone put
glasses, cups, ashtrays or cigarettes on the enclosure.
• Use a soft brush or a jet of air to clean the enclosure.
Do not use alcohol, solvents or detergents.
• Do not remove the protective grid.
• Take care of your connector cables. Make sure that
they are not damaged, knotted or twisted.
• Do not force connectors and controls.
• Make sure the mains power switch is off ('0') before
starting any connection.
14
ENGLISH
Power supply connection:
• Make sure that the mains voltage corresponds to
the voltage indicated on the rear panel.
• Use only the factory supplied mains cable or, if a
different plug style is needed, a suitable adapter
with a ground connection and marked with the
safety approvals valid in the country of use.
Connection to the Mic, Line 1 and Line 2
inputs and to the Mixed Line output:
• Always make sure to use only heavy gauge, high
quality SHIELDED cables (signal cables).
• Always make certain that the mixer or the instrument
and the powered enclosures are switched off before
connecting them. This will avoid annoying noises and
signal peaks, which can also be dangerous for the
enclosures themselves.
See 'connections' and 'applications' at pages
19, 20, 21 and 22.
Parallel connection of two or more MT200A:
- use mono Jack connectors.
Connect the Mixed Line Out of the MT200A to one
of the two Line Inputs of the 2
See 'connections' at page 19.
nd MT200A and so on...