Panasonic WV-CF224 Service Manual page 6

8 Referring to Fig. 2-3, remove two screws and three washers
that secure the Main Unit, and remove the Main Unit from
the Camera Unit.
Washers
Fig. 2-3
8 Referring to Fig. 2-4, remove two screws that secure the
Camera Bottom Case and remove the Camera Bottom
Case from the Main Unit.
8 Disconnect the Connector CN3 on the Main Board and
remove the Wire Ass'y.
Main Unit
Camera Bottom Case
Wire Ass'y
Fig. 2-4
Main Unit
Washer
Camera Unit
Remove two screws.
Main Board
CN3
Remove two screws.
8 Referring to Fig. 2-5, remove two screws that secure the
Main Board, disconnect the Connector CN1 on the Main
Board and remove the Main Board from the Main Unit with
the Sensor Board in order to service the Main Board.
8 Remove two screws that secure the Sensor Board and
remove the Sensor Board from the Main Unit in order to
replace the Optical Ass'y (IC1) or service the Sensor Board.
Sensor Board
Optical Ass'y (IC1)
Main Board
Remove two screws.
8 Reconnect the connectors by using Extension Cable Ass'y
between CN1 on the Sensor Board and CN1 on the Main
Board as follows in order to service.
8 Referring to Fig. 2-6, connect the Connector CN1 on the
Extension Cable Ass'y to CN1 on the Sensor Board.
8 Connect the Connector CN3 on the Extension Cable Ass'y
to CN1 on the Main Board.
CN3
Main Board
(Camera Unit)
2-2
Main Unit
CN1
Remove two screws.
CN1
Fig. 2-5
Extension Cable Ass'y
CN1
CN1
CN1
Sensor Board
Fig. 2-6