Cisco Catalyst 2960-L Getting Started Manual page 6

Installing the Switch
Class 1 laser product. Statement 1008
Warning
Do not stare into the laser beam. Statement 1010
Warning
Warning This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device. Statement 1019
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
Warning
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some
LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
Warning
1022
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected
last. Statement 1046
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: <113°F (45°C). Statement 1047
Cisco Catalyst 2960-L Switch Getting Started Guide
6
Getting Started with the Switch