Installation and Accessory Parts
Unpacking Your Wine cellar
1.Remove all p ackaging m aterial; this includes the foam base and all adhesi ve
tape holding the Wine cellar accessories inside and outside.
2.Inspect and rem ove any remains of p acking, t ape or printed material s before
powering on the Wine cellar.
Adjusting Your Wine cellar
1.Your W ine cellar is designed for freest anding installation onl y. It should not be
recessed or built-in.
2.Place the Wine cellar on a floor strong enough to support it fully loaded.
3.When moving the Wine cellar , never tilt it more than a 45-degree angle. Thi s
could damage the compressor and the sealed system.
4.If the Wine cellar is tilted let it st and in an upright position for at least 24 hours
prior to plugging. This is to allow the refrigerant to settle.
·Proper Air Circulation
To assure your W ine cell ar works at the maxi mum efficiency i t was desi gned
for, you should install it in a location where there is proper air circulation,
Plumbing and electrical connections.
The following are recommended clearances around the Wine cellar:
Sides..............0.8"(20mm)
Top. ...............6.3"(630mm)
Back..............4"(100mm)
6