Problem Solver - GE ZBD1850 Owner's Manual

Questions?
PROBLEM
Use this
White film on inside
surfaces
problem
solver
Dishes don't dry
Dishwasher won't run
Steam
Control panel
responded to input
but dishwasher never
filled with water
Dishwasher beeps
once every 15 seconds
Beeping at the end of
the cycle
LOW RINSE AID light
is on
Before You Call For Service
POSSIBLE CAUSE
Hard water minerals
Low inlet water
temperature
Rinse agent dispenser
is empty
Fuse is blown, or the
circuit breaker tripped
Power is turned off
Reboot your control
This is normal
Door latch may not be
properly seated
Water valve may be
turned off
This is normal
This is a reminder that
the door has been left
open during operation
This is normal
Rinse aid dispenser needs
to be refilled
Dishwasher
WHAT TO DO
• To clean the interior, apply dishwasher
detergent to a damp sponge. Wear rubber
gloves. Do not use any type of cleanser
other than dishwasher detergent because
it may cause foaming or sudsing. Cascade
automatic dishwashing detergents have
been approved for use in all Monogram
dishwashers.
• Make sure inlet water temperature is
correct (see page 12).
• Check the rinse agent dispenser.
• Replace fuse or reset circuit breaker.
Remove any other appliances from
the circuit.
• In some installations, the power to the
dishwasher is proved through a wall switch,
often located next to the disposer switch.
Make sure it is on.
• Turn off power to the dishwasher (at the
circuit breaker or wall switch) for
30 seconds; then turn back on.
• Steam comes through the vent during
washing, drying and when water is being
pumped out.
• Make sure the door is firmly closed.
• Make sure water valve (usually located
under the sink) is turned on.
• Close the door after opening it mid-cycle.
• Press ON/OFF to turn OFF the dishwasher.
• The dishwasher will beep and the CLEAN
light will display at the end of the wash
cycle.
• This can only be turned off by filling the
rinse aid dispenser with Cascade®
Complete Rinse Aid. See Refilling the
Rinse Aid Dispenser section.
®
21