Hybrid Module M327 (Opt); General Notes For Installing The Module M327 - Meta System EasyCan Digital Installation Instruction

With the hybrid module M327 you can have one or more additional remote controls besides the original
one and by means of which it is possible to control centralised locking, the blinkers, releasing the trunk
and the EasyCan alarm.
By using the remote control that comes with the control unit M327 you can also inhibit, by pressing twice on the
lock key, the ultrasound protection device thus preventing activation of the car's instrument panel.
FUNCTIONS AVAILABLE THANKS TO MODULE M327 (they have to be selected with the PDC/Alarm Programmer)
1) Choosing the control TIME of CENTRALISED LOCKING most suited to the vehicle (factory setting 0.5 seconds). To change
the time, connect the PDC/Alarm programmer to the M327 and selection 2- LOCKING TIMES and choose the time wanted
(0.5 - 1.5 - 4.5 sec).
2) Choosing the type of COMFORT preferred that allows the windows to close on cars with this feature;
There are 3 possible selections: COMFORT OFF / COMFORT / AUTOMATIC COMFORT-. To choose the COMFORT you prefer,
connect the PDC/Alarm programmer to the M327 and selection 3- COMFORT and choose the one you want.
Choosing COMFORT: It activates complete closing of the windows all the time the door lock key is pressed.
Choosing AUTOMATIC COMFORT: It activates complete closing of the windows after the doors have been locked.
3) CAR-FINDER function: If this option is activated it lets you fi nd your car as it makes the blinkers fl ash.
To activate the CAR-FINDER function, connect the PDC/Alarm programmer to the M327 and programme YES for selection
7- CAR-FINDER.
4) TRUNK RELEASE function: If this function is activated it allows you to control a trunk release relay.
To activate the TRUNK RELEASE function, connect the PDC/Alarm programmer to the M327 and programme ENABLED for
selection 5- TRUNK RELEASE.
5) Safety closing of the locks with DEAD LOCK; on cars with this feature, it prevents the release of the closing lever inside
the door unlock.
To activate this function, connect the PDC/Alarm programmer to the M327 and programme YES for selection 4- DEAD
LOCK.
NOTE: If the DEAD LOCK function is activated it inhibits use of the COMFORT and AUTOMATIC COMFORT functions.
6) DOOR SIGNAL function: This is an alternative to the TRUNK RELEASE function which, if activated, converts the door
opening CAN BUS signal into an analogue signal that can be used by the SATELLITE pager.
To activate the DOOR SIGNAL function, connect the PDC/Alarm programmer to the M327 and programme ON for selection
9- DOOR SIGNAL.
7) Activation of the blinkers when the alarm is activated and deactivated by means of an additional remote control.
To activate this function, connect the PDC/Alarm programmer to EasyCan and programme YES for selection 3-Blinker Act/
Deact and enter the number of fl ashes wanted upon activation and deactivation of the alarm so they are the same whether
the original radio remot control is used or the M327 radio control.

HYBRID MODULE M327 (OPT)

25

General notes for installing the module M327:

For centralised locking connection please refer
to the customised technical data sheet for the
car type and use the programmer to alter the
set-up of the M327 module and to exploit its
functions to the full.
• The M327 module is combined automatically
with EasyCan when the +15 panel is activated
for the fi rst time and, for a question of safety, it is
impossible to replace the combined module with
a new one before the alarm has been set for the
combination with a new M327 by means of the
PDC/ALARM Programmer.
Fig. 22