Lo Generation And Distribution Circuit - LG KC910 Service Manual

3.5 LO GENERATION and DISTRIBUTION CIRCUIT

3.5.1 UMTS PAM (U105: AWT6277R)
The integrated LO generation and distribution circuits are driven by internal VCOs to support various
modes to yield highly flexible quadrature LO outputs that drive all GSM/EDGE, UMTS band and GPS
up-converters and down-converters; with the help of these LO generation and distribution circuits, true
zero-IF architecture is employed in all GSM and UMTS band receivers and transmitters to translate the
signal directly from RF-to-baseband and from baseband-to-RF.
Two fully functional fraction-N synthesizers, including VCOs and loop filters, are integrated within the
RTR6285 IC. In addition, the RTR6285 has a third synthesizer used for GPS operation. The first
synthesizer (PLL1) in the RTR6285 creates the transceiver Los that support the UMTS transmitter,
and all four GSM band receivers and transmitters including: GSM850, GSM900, GSM1800, and
GSM1900. The second synthesizer (PLL2) in the RTR6285 IC provides the LO for the UMTS primary
receiver. For the RTR6285 IC only, the second synthesizer also provides the LO for the secondary
UMTS receiver. The third synthesizer (PLL3), only in the RTR6285 IC, provides the LO for the GPS
receiver.
An external TCXO input signal is required to provide the synthesizer frequency reference to which the
PLL is phase and frequency locked. The RTR6285 ICs integrate most of the PLL loop filter
components on-chip except for three off-chip loop filter-series capacitors, which significantly reduces
off-chip component requirement. With the integrated fractional-N PLL synthesizers, the RTR6285 ICs
have the advantage of more flexible loop bandwidth control, fast lock time, and low-integrated phase
error.
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
3. TECHNICAL BRIEF
- 27 -
LGE Internal Use Only