Unit Names And The Functions - FujiFilm DR-ID 670 Operation Manual

2.2 Unit Names and the Functions

Unit names and the functions of the DR-ID 670 are described below.
2
Flat panel sensor
(DR-ID 601SE, DR-ID 602SE, DR-ID 611SE and DR-ID 612SE)
Power supply unit (DR-ID 600MP)
Name
Flat panel sensor
Status lamp
READY
POWER
ERROR
Power supply unit
(DR-ID 600MP)
Main switch
Power status LED
Control software I/F library
(DR-ID 670MC)
2-2
DR-ID 670 Operation Manual
Applied part
Connector
Status lamp
* Exposure plane is shown in this figure.
Power
status LED
Main switch
DR-ID 601SE and DR-ID 602SE incorporate a GOS indirect panel. The DR-ID 611SE,
DR-ID 612SE and DR-ID 613SE incorporate a CsI indirect panel.
There are five types of flat panel sensors: DR-ID 601SE, DR-ID 602SE, DR-ID 611SE,
DR-ID 612SE and DR-ID 613SE (wireless/wired communication mode).
Indicates the equipment status by LEDs.
READY (Green)
POWER (Green)
(In wireless communication
mode, the status of the battery
pack is indicated. In wired
communication mode, the
power status is indicated.).
ERROR (Orange)
* All LEDs are off when the equipment is off.
Supplies the power to the flat panel sensor and connects the flat panel sensor and the
control cabinet.
Supplies the power to the flat panel sensor and the inside of the power supply unit.
Displays ON/OFF of the power supply unit.
Controls the flat panel sensor.
897N102735
Flat panel sensor (DR-ID 613SE)
* Exposure plane is shown in this figure.
Description
On Exposure possible
Blinks for 1.0 During exposure sequence
second.
Off Ready
Wireless
On OK (Power ON)
Less than 10 min.
Blinks for 1.0
second.
Off Empty (Power OFF) Power OFF
On Communication not possible.
Blinks for 1.0 Error occurred
second.
Off Normal
Applied part
Connector
Status lamp
Wired
Power ON
-