Remote Control Button Operations - Toshiba RBC-SR1-PE Owner's Manual

AI R
R C
EMOTE
MODE FAN
FAN ONLY AUTO
COOL HIGH
MED
HEAT LOW
AUTO
TEMP CHECK
UNIT
88
TIMER CONT. OFF ON
88 : 88
H
1. MODE Button
Selects the desired operation mode. Each time it
is pressed, the display changes in the following
sequence:-
FAN ONLY COOL HEAT AUTO
2. FAN Button
Selects the desired fan speed mode. Each time it
is pressed, the display changes in the following
sequence:-
AUTO HIGH MED LOW
3. LOUVER Button
This is used to drive the outlet louvers
automatically when the air conditioner is in
operation. When it is pressed, the louvers will
start oscillation and the display will illuminate.
When it is pressed again, the louvers will stop.
4. TEMP ADJUST ( ) Buttons
These buttons are used to set the required room
temperatures (18-29°C).
5. TIMER Button
When the air conditioner is switched off, the operation lamp and LOUVER display go off, but the
other displays remain unchanged.
Use the CHECK button for a malfunction check. Do not operate this button under normal
GB
C
EMOTE ONTROLLER
B O
ONTROL UTTON PERATIONS
1 2 3
NETWORK
CENTRAL
REMOTE CONTROLLER
OPERATION
STANDBY
MODE
PREHEAT
DEFROST
FILTER
- +
LOUVER
MANUAL
˚ C
TIMER ADJUST
ADDRESS
CHECK FILTER
M
ON/OFF
9 10 7 8
6. TIMER ADJUST Buttons
7. OPERATION Lamp
On initial power on or after a power interruption
this lamp will flash. This lamp is lit during normal
operation.
8. ON/OFF Button
When this button is pressed, the machine starts
or stops within a couple of minutes.
9. CHECK Button
10. FILTER Button
CHECK button and FILTER button are for the
use of service engineers.
CAUTION
– 5 – – 5 –
4
6
5