Table of Contents
Advertisement
contact surfaces can cause water to
enter inside. Do not install or remove
the au Nano IC Card (LTE) tray or
microSD memory card tray with gloved
hands. Just a small particle (a hair,
etc.) between contact surfaces can
cause water to enter inside. Wipe off
any minuscule droplet of water or dirt
with a clean dry cloth before closing
the cover.
If either of au Nano IC Card (LTE) tray
or microSD memory card tray is
deteriorated or damaged, the
waterproof property becomes
ineffective. In such case, contact an
au shop near you.
• If any liquid other than plain water
gets on the product
If any liquid other than plain water (e.g.
seawater, detergent, alcohol) gets on
the product, immediately rinse it with
plain water.
You can wash the product under a
mild flow (less than 6 litters per
minute) of tap water at room
temperature (5℃ to 35℃) at a
distance of about 10 cm from the
faucet or showerhead.
If the product gets dirty, wash it with
your hands without using a brush, etc.
while holding the au Nano IC Card
60
Advertisement
Table of Contents
