Onkyo DR-S2.2 Service Manual page 88

UPGRADE FIRMWARE-8
3 Setting the regional code
Do not need to do this work about UDD1N type.
FL display
REGION INI
Operate it using remote controller (RC-484M).
1. Press hold down the DVD button, then
press 2(SP SETUP) buton.
2. Press the number button which suits each destination.
Correspondence table
Operation button name
Destination
MDD1N Region cord is set automatically.
MPP2P
UPT3P
UDT3P
UGK3P
UPA4P
UDS4P
UGR6P
FL display
NO DISC
3. Turn OFF power of DR-S2.2.
4. Disconnect DR-S2.2 and the PC.
Chack firmware and regional cord
4
You check whether it is set up firmware and repional cord correctly.
Refer to 1 about check procedure.
TV Monitor
[player's Region setting]
<1> : Region 1
<2> : Region 2
<3> : Region 3
<4> : Region 4
<5> : Region 5
<6> : Region 6
Pick out any one of these!
Region code
1
2
2
3 3
3 3
3 3
4
4
4
4
6 6
Page 88
1
2
DR-S2.2