Service Information; Printing Paper Replacement - Texas Instruments TI-5015 Operating Manual

SERVICE INFORMATION
PRINTING PAPER REPLACEMENT
A roll of thermal printing paper was included with your Tl-5015 calculator.
When you near the end of the roll, a continuous stripe will appear to the right
of
the printout to indicate that there are approximately ten feet of paper left in
the roll. As you continue operating the calculator, check to make sure that
sufficient printing paper remains to complete your calculations.
When replacing the paper in your Tl-5015, use only Texas Instruments
TP-20225 or TP 27225 thermal printing paper. Other thermal papers
may damage your calculator and void the warranty. New paper may be
obtained at the store where your Tl-5015 was purchased.
If
your local store
is temporarily out of paper, you may order it from Texas Instruments Service
Facility,
P.O.
Box
53,
Lubbock, Texas 79408.
Follow these steps to install new paper:
1. Lift the old roll
of
paper from the calculator and cut or tear the paper to
separate the end of the roll from the paper remaining in the printing
mechanism.
STRIPE
23