Sun Shade Movement; Pinch Protect Feature; Vent Opening - Alfa Romeo Giulia 2017 Owner's Manual

Caution!
Do not open the sun roof if a roof rack or
crossbars are fitted. Do not open the sun
roof if there is snow or ice on it: you may
damage it.
Closing
From the complete open position, push
the open/close button toward the front
of the vehicle. The roof will close
completely.
The automatic motion can be
interrupted in any position by pushing
the open/close button again.

Vent Opening

To bring the roof into vent position,
push and release the vent button.
This type of vent opening can be
activated regardless of the position of
the sunroof. When starting with the roof
in the closed position, pushing the vent
button automatically causes the sunroof
to open to the vent position. If the roof
is already open, the button must be
held until the roof reaches the
vent-opening position.
Pushing vent button again during
automatic movement of the roof will
stop it.

Sun Shade Movement

The front sunshade is power operated.
Push the Power Shade open/close
button toward the rear of the vehicle to
open the front sun shade.
Push the Power Shade open/close
button toward the front of the vehicle to
close the sun shade.
The automatic motion can be
interrupted in any position by pushing
the Power Shade on/off button again.
To open the rear sunshade, pull
sunshade manually toward the rear of
the vehicle.

Pinch Protect Feature

The sunroof has an anti-pinch safety
system capable of detecting the
presence of an obstacle during the
closing movement. If an obstacle is
detected, the system intervenes and
the movement of the sunroof is
immediately reversed into opening.
Initialization Procedure
Automatic operation of the sunroof
must be initialized again in case of faulty
sunroof operation.
Proceed as follows:
1. Push the open/close button to bring
the roof into the completely closed
position.
2. Cycle the ignition to the STOP
position and wait at least ten seconds.
3. Cycle the ignition to the AVV
position. Refer to "Ignition" in this
chapter for further information.
4. Hold the open/close button down
for at least ten seconds. You should
then hear the mechanical stop of the
roof motor.
5. Within five seconds, hold the
open/close button down. The roof will
perform a complete automatic opening
and closing cycle (to indicate that the
initialization procedure has been
successful). If this does not occur, the
procedure must be restarted from the
beginning.
53