Forward/Rearward Adjustment; Seatback Recline; Seat Angle Adjustment (Tilting); Power Bolster Adjustment - Alfa Romeo Giulia 2017 Owner's Manual

Caution!
Do not place any article under a power seat
or impede its ability to move as it may
cause damage to the seat controls. Seat
travel may become limited if movement is
stopped by an obstruction in the seat's
path.

Forward/Rearward Adjustment

Push the seat switch forward or
rearward to adjust to your desired
position.

Seatback Recline

The angle of the seatback can be
adjusted forward or rearward. Push the
seatback switch forward or rearward,
and the seat will move in the direction
of the switch. Release the switch when
the desired position is reached.
Power Lumbar — If Equipped
Vehicles equipped with power driver or
passenger seats may also be equipped
with power lumbar. The power lumbar
switch is located on the outboard side
of the power seat. Push the switch
forward or rearward to increase or
decrease the lumbar support. Push the
switch upward or downward to raise or
lower the lumbar support.
Height Adjustment
The height of the seats can be adjusted
up or down. Pull upward or push
downward on the seat switch, and the
seat will move in the direction of the
switch. Release the switch when the
desired position is reached.

Seat Angle Adjustment (Tilting)

The seat angle can be adjusted in four
directions. Lift or push the front part of
seat switch to move the front part of the
seat in the corresponding direction.
Release the seat switch when the seat
has reached the desired position.

Power Bolster Adjustment

Push the power bolster adjustment
buttons to regulate the width of the
backrest through the lateral padding.
Seatback Width Adjustment
4 — Power Adjustable Bolster Buttons
5 — Driver Memory Seat Buttons
Driver Memory Seat
The driver memory seat buttons can
store and recall three different driver's
seat positions as well as outside power
mirror positions. Storing and recalling is
possible with the ignition in the ON or
STOP positions and the driver's side
door closed, or for three minutes after
having opened the driver's side door.
The performed position memory is
confirmed by a beep. To set a memory
profile, first adjust your seat (and power
mirror position if desired) with the
various controls until you are in the
desired position. Then, push the
specific button you want to assign the
set position to for 1.5 seconds. When a
new seat position is memorized, the
previously memorized position on the
same button is automatically
overwritten. Recalling a memorized
position is also possible for
approximately three minutes after the
doors are opened and approximately
one minute after the engine is stopped.
To recall a memorized position, push
the relevant button briefly.
04066S0015EM
27