Canon VC-C3 Instruction Manual page 7

21. Do not install the equipment in the
following locations as this can cause a fire
or electric shock:
- Hot locations
- Close to a fire
- Very humid or dusty locations
- Locations exposed to direct sunlight
- Locations exposed to salt spray
- Close to flammable solvents (alcohol,
thinners, etc.)
22. When any of the following occurs,
immediately switch OFF the equipment,
unplug it from the main power supply and
contact your nearest Canon supplier. Do
not continue to use the equipment as this
can cause a fire or electric shock.
- The equipment emits any smoke, heat,
abnormal noise, or unusual odor
- A metal object falls into the equipment
- The equipment is damaged in some
way.
23. Please observe the following when using
the equipment. Failure to do so can result
in a fire or electric shock.
- Do not use flammable spr ays near the
equipment.
- Do not subject the equipment to strong
impacts.
24. Please observe the following when
handling the batteries. Failure to do so can
result in the batteries bursting or emitting
heat, sparks or corrosive fluid.
- Do not throw the batteries into a fire,
and do not heat, short-circuit or
attempt to disassemble the batteries .
- Do not attempt to recharge the
batteries.
- Do not use batteries other than those
specified for use with the equipment.
25. Please observe the following when
handling the batteries. Failure to do so
may result in the batteries bursting or
emitting heat, sparks or corrosive fluid.
- When the batteries are used up, or
when the equipment will not be used
for an extended period, remove the
batteries.
- When replacing the batteries, alw ays
replace both batteries, and do not use
different types of batteries together.
- Ensure that the + and - terminals are
correctly positioned when you load the
batteries.
- If any soiling or leakage of the internal
battery fluid occurs, thoroughly clean
the soiling or leaked fluid with water.
7