Using the VC-C3
First check that the components are correctly connected. (P.12)
Turning the Units ON and OFF
There are power switches available on both the camera control unit and the base.
While these switches can be used in either order, VC-C3 operation differs
depending on the circumstances.
The camera control unit's main power switch ON and the
base power switch ON
The LEDs on the base, camera head and camera control unit are green and the
image appears on the monitor.
Camera
(base ON)
The VC-C3 is set to auto-focus mode when it is first turned on or when power is
recycled.
If any of the connection cables are disconnected while the base or camera
control unit is powered ON, then proceed as follows:
1. Turn the base power switch and the camera control unit's main
power switch OFF.
2. Connect the cables correctly.
3. Turn the base power switch and the camera control unit's main
power switch ON again.
16
Base power switch
Camera control
unit (ON)
Camera control unit
main power switch
Monitor (ON)