SYMA X5SW EXPLORERS Manual page 6

3.
Horizontal correcting function
:
Place the quadcopter on a horizontal postion,
then push transmitter both left and right lever
to lowest right conner for about 2-3 second
,
indicator on
the quadcopter changed from
normal lights
up
to quickly
flashing ;After 2-3
second ,the indicator changed to normal lights,
it means the
quadcopter restarted /reset
successfully.
4.3D eversion:
When you are familiar with the basic operation,
you can do some awesome& exciting tricks
and
stunts! First of all,fly the aircraft to a height of
more than 3 meters, press the 3D Eversion
switch on
the rear right side of the transmitter,
then push the right rudder(in any direction)
to make 360 degree flip.
5.Throwing
fl
ight instructions:
Thanks to the 6 axis gyroscope,you can
throw the quadcopter and push the throttle
right up,it will automatically level out and
hover smoothly
in
the
sky,
This can also
be
done when the
quadcopter is rolling.
6.Headless function:
1. Foruvard definition
1.
Turn on power switch of remote control.
-10-
ffi
t
K
2. Switch to headless
2.
After
aircraft connects with power supply, place
the
switch in "ON" position, adjust the direction
pointed by aircraft's handpiece and regard it as
the dead ahead in headless situation;
3. Push the accelerator's push rod of remote
control to the highest point and pull back to the
lowest point.
When remote control pops, it indicates that
frequency modulation and forward definition have
already finished.
function and general function
1.
After
frequency modulation, the aircraft defaults
to general pattern. The indicator light on aircraft
is long bright state.
After pressing down headless
function switch on the top left of master remote
controller for 2 seconds, remote control will give
out "DDD...", it means
that it enters into headless
state.
After pressing for 2 seconds and hearing long "D", it means that
it
exits headless state.(ln headless mode, four indicators on the aircraft
flicker slowly for once within four seconds)
2. ln headless state, the operator has no need to
recognize
the position of aircraft's headpiece,
and he
just needs to control the aircraft
in
accordance with the direction
of remote control's
operating rod.
3. Correcting fonivard
direction
1.
After aircraft crashes in headless state,
if
there
is
deviation in head direction,
it
just needs to adjust
the aircraft's direction again, pull remote control's
accelerator and operating rod to bottom left
simultaneously.
When indicalor light on the
aircraft flickers for slow three seconds,it means
that correction
is done.
ffi
1)
\\
fl*\
ffi