Download Print this page

Fakir Sprint Instruction Manual page 8

Advertisement

Available languages

Available languages

GENERAL USAGE EXPLANATION OF
THE APPLIANCE
Preparation for Use
• Fill 1,85 liters of water into the container.
The water level should not exceed the
"MAX" level indicated on the container. (
Add 2 part water with scaled measuring
cup )
• Fit the air distributing part (16) by sliding it
into its slot located on the container.
• Put the water separator (17) on the container
and place the SPONGE filter (18) on top of
it.
• Place the motor unit (1) on the container
(5) and secure it by locking the container
locking/unlocking parts (6) on each side.
• Connect the hose (9) to the inlet socket
located on the container (5). Attach the
extension tube (11) to the hose handle. You
can attach the accessories (12, 13, 14, 15)
directly to the hose handle without using
any tube.
Operating the appliance:
• After checking if the voltage meets the rated
voltage, plug in the appliance.
• Press on/off switch (20) located on the top
of the appliance.
• If the water becomes very dirty during
cleaning, replace it as described in the
"Maintenance and Cleaning the Appliance"
section.
Blower Function:
• Remove the blower cover lid and insert the
hose into the opening on the body.
CAUTION : THIS APPLIANCE IS NOT A
WET&DRY VACUUM CLEANER, BUT A
DRY VACUUM CLEANER WITH WATER
FILTRATION. AVOID SUCKING ANY TYPE
OF LIQUID WITH THIS VACUUM
CLEANER.
Maintenance and Cleaning the Appliance
• To empty the water inside the container,
switch off the appliance by pushing on the
On/Off switch and disconnect the power
supply cable from the mains.
• Remove the motor unit (1) after unlocking
the container locking/unlocking parts (6)
on each side of the container (5).
• Remove the water separator (17) and the
8
air distributing part (16).
• Empty the water inside the container by
tilting it towards the opposite side of the
inlet socket . You can use the handle of the
container.
• It is strongly recommended to dump the
water inside the container and to wash out
any dirt that might be remaining inside the
container after each use.
• It is recommended to wipe inside the
container with a dry cloth after washed.
• You may wash the SPONGE filter under the
water.
• It is recommended that the vacuum cleaner
is stored without water inside the container.
It is best to fill the filtration water (1,5 l) right
before the use.
Warnings
• Please make sure that the air distributing
part (16) and water separator parts (17)
are always in place when the vacuum
cleaner is operated.
• If the vacuum cleaner overturns accidentally
during operation, switch the unit off and
unplug immediately. Dump the water inside
the container and follow the cleaning
procedure described in "Maintenance and
Cleaning the Appliance" section, above.
Make sure that all the parts have been dried
before using the appliance again.

Advertisement

loading