Rapidheat; Whirlpool Operations - Jacuzzi Pure Air Operating Manual

English
Controlling Whirlpool Direction & Flow
CAUTION: Never run the whirlpool system with all the jets closed.
To adjust the direction of the jets:
• To change the direction of the water flow, swivel the jet nozzle to the desired angle (Figure 14).
To adjust the water flow to the jets:
• Increase the force of the flow by rotating the nozzle or jet face to the left (counterclockwise). Decrease the force of the
flow by rotating the nozzle or jet face to the right (clockwise). Reference Figure 15.
Fig. 14
Controlling Waterfall (Applicable Models Only)
The waterfall can only be activated when the whirlpool
pump is in operation.
The more the waterfall control knob is turned in a counter-
clockwise direction, the flow of water will increase. Reference
Figure 16.
To remove accumulations of bathtub residue from the system, it is recommended that a bathtub be cleaned at least twice
a month. For best results, however, we recommend that you clean your bathtub after each use using Systems Clean™,
our exclusive two-part plumbing system cleaner made specifically for bathtubs. Systems Clean™ is available through an
authorized Jacuzzi Luxury Bath distributor, by calling 1-800-288-4002 or may be purchased online at www.jacuzzi.com.
RapidHeat™ (Standard on Salon
The heater turns ON automatically any time whirlpool operation is active. Heater
operation is not displayed on the control panel. There is a visible indicator light on the
heater itself that signifies the heater is operating (Figure 17). The heater will help main-
tain the temperature of the water in the bathtub. It is not intended to heat the water to a
desired temperature.
Vacuum Switch
The heater is equipped with a preset vacuum switch which will not allow
the heater to turn ON if the pump is not running and water is not flowing
through the whirlpool system.
High-Limit Switch
The heater includes an exclusive High-Limit switch (Figure 17). This safety circuit will not false trip from hot tap water. It
will only turn OFF the heater if the thermostat fails. To reset, press the button. If the high-limit trips frequently, please con-
tact us at www.jacuzzi.com, or at 1-800-288-4002.
Page 10
Whirlpool Operations (Continued)

RapidHeat™

® Spa Models)
www.jacuzzi.com
Fig. 15
Turning ON...
Fig. 16
Turning the Waterfall Control knob
counter-clockwise will turn on the waterfall
Heater will only work when
the water temp is 77°F or
above. You should always fill
the tub with warm water.
Fig. 17
OVER HEAT
PROTECTION
PUSH TO RESE T
Operating Manual
Turning OFF...
Turning the Waterfall Control knob
clockwise will turn off the waterfall
IMPORTANT NOTE:
High Limit Heater
Reset On
HEATER ON