Firmware; Compliance - Polaroid Snaptouch User Manual

Firmware Updates
When you connect to the Polaroid Print App it will automatically check if there's an update available for your device. You'll
be prompted to perform a 2-step process: downloading and installing.
First you will be asked if you want to download the update now or later. If you press "DOWNLOAD NOW" the download
will start and you will not be able to use your camera or turn the camera off for a few minutes until the download has
completed.
When the download has completed, you will be asked if you want to install the update. Press "INSTALL NOW" to
begin the installation process. You will not be able to use your camera or turn the camera off for a few minutes until the
installation has completed. A progress bar will show you the installation status. After the firmware update has been
installed, the camera will automatically turn off. You will have to turn the camera on again.
If you choose to delay the installation process, it will automatically begin before the camera turns off, or when you close
the pop-up flash/power button. You can also go to settings > ABOUT to download and install firmware.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
"The device must not be co-located or operating in conjunction with any other antenna or transmitter. "
And the following additional information shall be contained in the user or instruction manual:
1) The Responsible party information: Name, Address, Telephone Number
2) The name and model number of the product
Notes: For systems incorporating several digital devices, the above statement needs to be contained only in the user
manual for the main control unit.
If shielded cables or special accessories are required for compliance, a statement must be included which instructs the
user to employ them, for example:
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
This device complies with RSS247 of Industry Canada. This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device. Radiation
Exposure Statement: The product comply with the Canada portable RF exposure limit set forth for an uncontrolled
14

Firmware

15

Compliance

20 | EN