Page 1
Quick Start Guide and FAQ GETTING STARTED WITH YOUR POLAROID SNAP Step 1: Charge your camera Plug the cable into a 1amp charge block and into your camera. Make sure the camera is laid flat on the ground and the cable is not fully extended.
Page 2
Step 3: Holding the camera for a selfie LOAD THE PAPER Step 1: Take the paper out of the foil. Do not separate the “BLUE COLOR CALIBRATION SHEET”. Step 2: Load the stack of paper with the “BAR CODE” side face down A and glossy side face up PRESS THE POWER BUTTON TO TURN ON THE CAMERA The LED light will turn white when ready and a chime will sound.
Page 3
The LED light will turn white when ready and a chime will sound. Does this printer print pictures from other devices? The Polaroid Snap only prints the pictures you take from the camera. It does not connect to other devices.
Page 4
There is a button on the Polaroid Snap that allows you to choose whether or not you want to apply a border to your picture. Once you press the button, it will light up and indicate that your next print will come out with a white border.