Sharp AY-XP08CE Service Manual page 37

[Cautionary points for assembling the fan]
a. When inserting the motor shaft into the metal fan
boss, take care to prevent injuring the inner surface of
the metal fan boss.
b. Before fastening the motor shaft and fan, insert the
motor shaft into the metal fan boss until it stops.
Cross flow fan
Fan boss
How to remove the display cover
2
1. Push the center of display cover from the back.
2. Slide the display cover to the right.
How to assemble the display cover
1. Slide the left end of the display cover through 2 hooks
on the front panel along the guide from the center of
the front panel.
2. After the left half is inseted completely, press the
display cover and snap in the 2 or 3 hooks on the
right.
Fan motor
Motor shaft
1
How to remove the control board
1. Remove the photo detector unit.
(Press and spread the upper hook, and the photo
detector unit will be ready for removal.)
2. Remove the screw fixing the terminal board.
3. Remove 2 screws fixing the board (transformer).
CN8 CN10
CN6
4. Remove 5 connectors. And cut off a fixing band.
37
AY-XP08/10/13CE
AE-X08/10BE-C
AE-X13BE
CN9
CN7