Sanyo VPC-GH3GX Service Manual page 17

3-6. The adjustment item which in necessary in part exchange
COMPL PWB CP1
COMPL PWB VF1
COMPL PWB ST1
COMPL PWB TB1
COMPL PWB TB2
COMPL PWB TB3
COMPL PWB TB4
ASSY, FLEXIBLE PWB CA1
LENS
: Be sure to carry out the necessary adjustments after replacing the unit.
: Adjustment is possible from the menu setting screen of the camera and by using the calibration software.
3-7. Updating the firmware
Check the firmware version immediately after the CP1 board has been replaced. If an old version is being used, interfer-
ence and errors in operation may also occur. If an old version is being used, update it with a newer version.
3-13. Firmware uploading procedure. (Page 21)
Refer to
3-8. Adjust Specifications
1. Lens Adjustment (1 m)
Camera
Lens
Lens
White Point
AWB
Adjust-
Adjust-
Adjust-
ment ment
ment
Adjustment
(1 m) (Infinity)
100 0.5 cm
Siemens
star chart
Black Point
And
Factory
White Point
Defect
Cord
Defect Detect
Detect
Setting
Adjustment
In Lighted
Preparation:
POWER switch: ON
Adjustment condition:
Siemens star chart (A3)
Fluorescent light illumination with no flicker
Illumination above the subject should be 700 lux ± 10%.
Note:
Do not vibrate during the adjustment.
If readjusting after it has already been adjusted, wait for 15
minutes or more for the unit to cool down first.
Adjustment method:
1. Set the siemens star chart 100 ± 0.5 cm from lens surface
so that it becomes center of the screen (zoom wide and
tele). Set the camera and the chart in a straight, and do not
put optical systems (mirror and conversion lens etc.)
2. Double-click on the DscCalDi.exe.
3. Click the "Focus", and Click the "Yes".
4. Lens adjustment value will appear on the screen.
5. Click the OK.
2. Lens Adjustment (Infinity) is carried out after this ad-
justment.
– 17 –
USB
Language
storage Reset
Setting
information Setting
registration