Upgrade Procedures; Upgrading The Software Programme And The Map Database - Pioneer T1000-23345 Update Instructions And Operation Manual

Instructions for upgrading
2 Record the password that you received.
You need to input this password accurately.
Write down your password to avoid mis-
takes.

Upgrade procedures

! NEVER stop the engine of your vehicle or
turn off the power supply to the navigation
system until the installation is completed.
Turning the power off during upgrade pro-
cess causes a malfunction or failure of the
navigation system.
! No functions are available during upgrade
process.
Upgrading the software
programme and the map database
This section describes the upgrade proce-
dures for your navigation system.
p The upgrade takes approximately 30 min-
utes in total.
1 Park your vehicle in a safe place and
apply the handbrake.
2 Insert the upgrade microSD card #1
(8 GB) into the SD card adapter.
p Step 2 is not necessary for AVIC-F920BT,
AVIC-F9210BT and AVIC-F9220BT.
3 Insert the upgrade microSD card #1
(8 GB) into the SD card slot.
The message confirming whether or not to
start the update will appear.
4 Touch [Yes].
The message confirming whether or not to
enter the password will appear.
5 Touch [Yes].
After a short pause, the keyboard for entering
the password will appear.
# If you touch [No], the device number
(Device #) of your navigation system will appear.
# If you touch [Cancel], the update will be can-
celled.
6 Enter the password for authentication
that you obtained, then touch [OK].
A message confirming whether to restart the
navigation system appears.
7 Touch [OK].
The navigation system restarts and then the in-
stallation begins.
Chapter
05
23
Engb