Test Operation - Haier HSU-12HNA/W Operation Manual

Operation
HEALTH Operation
(This function is unavailable on some models.)
Press HEALTH button to enter additional options, when
cycle display to , And then enter to health function.
The anion generator in the airconditioner can
anion effectively balance the
generate a lot of
quantity of position and anion in
also to kill bacteria and speed up the dust sediment
in the room and finally clean the air in the room.
Healthy Negative ions
Timer On/Off On-Off Operation
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:
0.5h 0.5h 0.5h
TIMER ON TIMER OFF TIMER ON-OFF
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER ON-OFF). "
3.Press / button to set time.
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first
12 hours decreased by 0.5 hour every time, after 12
hours,decreased by 1 hour every time.
It can be adjusted within 24 hours.
4.Confirm timer setting
After adjust the time,press
time ON or OFF button will not flash any more.
5.Cancel timer setting
Press the timer button by times until the time display
eliminated.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be achieved.
3
the air and
BLANK
0.5h
TIMER OFF-ON
"or " "will flash.
button and confirm the
POWER/SOFT Operation
(This function is unavailable on some models.)
(1)
POWER Operation
When you need rapid heating or cooling, you can use this function.
Press button to enter additional options, when cycle
display to , will flash，and then press
power function. When cancel the function, please enter
additional options again and to cancel power function.
(2) QUIET Operation
You can use this function when silence is needed for rest or reading.
Press QUIET button, the remote controller will show
and then achieve to the quiet function. Press again this
QUIET button , the quiet function will be cancelled.
Note ：
During POWER operation, in rapid COOL mode , the room
will show inhomogeneous temperature distribution.
Long period QUIET operation will cause effect of not too
cool or not too warm.
Emergency operation and test operation
Emergency Operation:
Use this operation only when the remote controller
is defective or lost.
When the emergency operation switch is
pressed,the" Pi "sound is heard once, which means
the start of this operation.
In this operation, the system automatically selects
the operation modes,cooling or fan or heat,according
to the room temperature.
Room
Operation Designated
temperature mode temperature
ABOVE 23 C COOLING 26 C
O
O
BELOW 23 C HEAT
O
23 C
O
(Cooling only uint） Operation
mode
Room temperature
FAN
BELOW 23 C
O
It is not possible to operate in dry mode.

Test operation:

Test operation switch is the same as emergency switch.
Use this switch in the test operation when the room
temperature is below 16
normal operation.
Continue to press the test operation
switch for more than 5 seconds. After
you hear the "Pi" sound twice,release
your finger from the switch: the cooling
operation starts with the air flow speed "Hi".
After 30 minutes, test operation ends automatically(Only for 22K,24K unit).
,enter to
Pi
Timer
Air flow
mode
NO
AUTOMATIC
AUTOMATIC
NO
Designated Timer
Air flow
mode
temperature
NO
26 C
O AUTOMATIC
o
C, do not use it in the
Pi Pi
,