Stanley STR-4 IN 1 Original Instructions Manual page 18

G
B
10
26a
Teil C
Teil B
18
- Lock the shaft of the brush cutter
at the intended location with a
screwdriver or with the hex key (28)
supplied.
- Turn the hex nut counter-clockwise to
26
the shaft and tighten itthe spark plug
wrench (29).
ATTENTION: Left hand thread
Connecting the drive unit and
Assembly:
10
Plug in the ends of the connected
26a
a modules together. Make sure that the
locking pin (26) snaps into place. Check
by pulling aparton a trial basis. Fold
26
down cover (26a) and secure assembly
by tightening the locking screw (10).
Release of the drive unit and
Assembly:
Release the locking screw (10).
The cover (26a) jumps back. Hold the
locking pin under the cover pressed
down (26) and at the same time
loosen the modules from one another
simultaneously by carefully pulling
apart.
The blade must be polished only by
suitably qualified and experienced
specialists.
Improperly polished blades increase
the risk of breakage and cracks.