F5 ARX 4000 Hardware Installation Manual page 86

Appendix A
Removing and Replacing FRUs
SWITCH> show chassis
Identification:
Hostname
------------------------------------ --------------------------------------
SWITCH
Chassis:
Chassis Type Model Number
------------ ------------------------------------
ARX-4000 SR2500ALLXR
.
.
.
Logical Disk Details:
Disk Status
------ ---------------------
1 Optimal
Disk Details:
Disk Size
-------- -----------
Bay 1 136.73G
Bay 2 136.73G
Replacing a Disk Drive
A - 10
The system will notify you of an internal disk failure through the CLI or an
SNMP trap. If you receive an e-mail notification of a internal disk failure (or
potential failure), consult the ARX SNMP Reference, Internal Disks, on page
1-7.
The following example output from the CLI
two disks installed and online – Bay 1 and Bay 2:
UUID
67e86988-2127-11dd-87e9-73f01551d963
Verification Mode
-----------------
Automatic
State Transfer Rate
----------------- -------------
Online 3.0Gb/sec
Online 3.0Gb/sec
WARNING
Static electricity can damage switch components. Be sure to wear antistatic
straps before handling disk drives.
To remove a disk drive:
1. Ensure that the front bezel has been removed. For instructions, see
Installing and Removing the Front Bezel, on page A-5.
2. Press in on the green latch at the front of the hard drive carrier.
3. Pull out on the black lever to slide the carrier from the system.
4. Remove the four screws that attach the hard drive to the drive
carrier. Lift the drive from the carrier and store it in an anti-static
bag.
5. Remove the hard drive from its wrapper and place it on an antistatic
surface.
6. With the drive circuit-side down, position the connector end of the
drive so that it is facing the rear of the drive carrier.
show chassis
HW Ver. Serial
------- -------------
BZDS72000184
Verification Rate
-----------------
10 %
Model
-----------------
ST3146855SS
ST3146855SS
command shows