Fujitsu PRIMERGY RX300 S4 Options Manual page 35

Processors
Figure 15: Installing heat sink
Ê Place the heat sink on the processor.
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
V
CAUTION!
Never install a processor without a heat sink as otherwise the processor
may overheat, causing a shut-down of the system.
Ê Reinstall the air duct over the memory and processors see
duct" on page
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
RX300 S4
81.
Options Guide
Installing a second processor
81.
"Inserting air
35