Driver Installation - D-Link DGE-530T User Manual

Section 2 - Installation
Note: Due to a fault in some Plug-and-Play BIOS programs, occasionally a newly installed adapter is assigned an Interrupt Number
which has already been assigned to another device. In such a case, the conflict of the Interrupt Number will cause faults in the behavior
of both devices. Therefore, the user must run the CMOS Setup utility and manually assign a non-conflicting Interrupt Number.
Connecting the Network Cable
1000BASE-T Gigabit Ethernet enables operation over the installed base of legacy CAT5 cabling systems as well as the CAT5
cabling systems currently being installed.
It provides optimal full-duplex 1000 Mb/s Ethernet service over Category 5E links as defined by ANSI/TIA/EIA-568-A-5. Topology
rules for 1000BASE-T are the same as those used for 100BASE-T. Category 5 and 5e link lengths are limited to 100 meters.

Driver Installation

Step 1
If the CD Autorun function does not automatically start on
your computer, go to Start > Run. In the run command box
type "D:\autorun.exe" (where D: represents the drive letter of
your CD-ROM drive).
Drivers for non-Windows operating systems are located on
the D-Link CD.
When the autorun screen appears, click Install Drivers (this
will launch the Network Utility program and install the drivers).
An Installation Wizard will guide you through the process, no
matter which operating you're running. Your DGE-530T will
be installed successfully in just a few moments, allowing you
to enjoy the many advantages of an Ethernet LAN.
D-Link DGE-530T User Manual 11