Networking Basics; Check Your Ip Address - D-Link DGE-530T User Manual

Gigabit desktop pci adapter

Hide thumbs Also See for DGE-530T:

Table of Contents

Appendix A - Networking Basics

Networking Basics

After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP

server (i.e router) automatically. To verify your IP address, please see the following steps below.

Windows® 8: Press and hold the Windows key and then press R. In the run box type cmd and press Enter.

Windows® 7/Vista®: Click on Start > All Programs >

Accessories > Command Prompt.

Windows® 2000/2003/XP: Click on Start > Run. In the

run box type cmd and click OK.

At the prompt, type ipconfig and press Enter.

This will display the IP address, subnet mask, and the

default gateway of your adapter.

If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software

programs may block a DHCP request on newly installed adapters.

D-Link DGE-530T User Manual

Table of Contents