Janome stirling Manual page 25

q
z x
(C)
(B)
c v
m
AFTER SALES SUPPORT
AUS 1300 526 663
AUS Hotline Costs
w e
r
(A)
b n
Buttonhole
q Pattern selector:
w Presser foot:
e Thread tension:
r Stitch length:
* Make a test buttonhole on a sample duplicating
the fabric, interfacing and seams of the actual
garment.
* Place the button on the fabric sample and mark
the top and bottom to determine the position of
the buttonhole.
* Use interfacing on stretch fabrics.
z Carefully mark buttonhole length on fabric.
Place the fabric under the foot with the
buttonhole marking running toward you.
x Move the slider (A) toward you so that the top
mark (C) on the slider meets the start mark (B).
Line up the markings on the foot with the top
mark on the fabric.
NOTE:
The scale on the slider is engraved in
centimeters.
c Set the pattern selector dial at " ".
Sew forward until you reach the front marking of
your buttonhole.
Stop sewing at a left stitch.
v Set the pattern selector dial at " ".
Sew 5 stitches. Stop sewing at a right stitch.
b Set the pattern selector dial at " ".
Sew until you reach the back marking of the
buttonhole. Stop sewing at a right stitch.
n Set the pattern selector dial at " ".
Sew a few bartacks and raise the needle from
the fabric.
Set the pattern selector dial at a straight stitch.
Sew a few locking stitches.
m Remove the fabric from the machine and cut the
sewing thread. Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
enquiries@esqaustralasia.com.au
MODEL: 311 PRODUCT CODE: 52829 04/2016
(BH)
Sliding buttonhole foot
1–5
25