Eikon Mains Panel - PROEL EIKON series User Manual

13. LO-CUT switch
Set this switch OFF to send at L and R OUTPUTs the same signal of L and R INPUTs respectively: typically
use this setting if the signal is sent to a speaker with built-in LO-CUT/HIGH PASS filter.
Set this switch ON to send at L and R OUTPUTs a LO-CUT/HIGH PASS filtered signal of L and R INPUTs
respectively: use this setting for a STEREO system with EIKON monitors.
14. LO-CUT potentiometer
With this control you set the frequency (80 – 120 Hz range) of the LO-CUT filter applied to the signal
sent to the main studio monitors (see examples for the most used settings with EIKON studio monitors).
15. LINK OUTPUT
Use this output to send the input signal to another subwoofer if you want to enhance the system's low-
frequency response (see also the EIKON10S block diagram).
16. HI-CUT potentiometer
With this control you set the frequency (80 – 120 Hz range) of the HI-CUT filter applied to the signal sent
to the subwoofer (see examples for the most used settings with EIKON studio monitors).
17. PHASE
This switch reverses the polarity of the subwoofer. Depending on the placement of the subwoofer with
relation to the studio monitor, you can get a better low-frequency response in the room if you reverse
the polarity of the subwoofer's signal (see examples for the most used settings with EIKON studio
monitors).
18. LEVEL
This potentiometer sets the level of the signal sent to the subwoofer amplifier.
19. ON
RED LED that shows the "ON" status of the subwoofer.

EIKON MAINS PANEL

20. POWER
Use this switch to power ON or OFF the loudspeaker. It is
"ON" when the switch is in the "I" position.
21. AC~ SOCKET
Here's where you plug in your mains supply cord. You
should always use the mains cord supplied with the
device. Be sure that your device is turned off before you
plug the mains supply cord into an electrical outlet.
22. FUSE holder / VOLTAGE SELECTOR
Here is where the mains protection fuse is placed.
REPLACE THE PROTECTION FUSE ONLY WITH THE
SAME TYPE.
IF, AFTER
INTERRUPTS AGAIN, DO NOT TRY AGAIN THEN CONTACT
THE PROEL SERVICE CENTER.
The fuse holder also behaves as switch to set the AC voltage line of your country (usually it is set by
factory and isn't necessary to change it).
WARNING: be careful to insert the voltage selector for the correct AC LINE VOLTAGE, an
incorrect setting of AC LINE VOLTAGE could damage seriously the internal electronics!
8
THE REPLACEMENT, THE FUSE