GE GTD42GASJ0WW Installation Instruction page 15

Installation Instructions
SIDE OR BOTTOM VENTING
Dryer Exhaust to right of cabinet for Electric
models only.
Dryer Exhaust to left of cabinet for Gas and
Electric models.
Dryer Exhaust to the bottom of cabinet for
Gas and Electric models.
- Fire Hazard
Close the back opening with cover plate (Kit
WE1M454).
Disconnect dryer from electrical supply.
Wear gloves and arm guards.
Failure to do so may result in fire, electrical shock
or lacerations.
Right
(electric
models
only)
Remove
screw
and save
O" Left
Bottom
Remove desired
knockout (one only)
Detach and remove the right (electric models only),
left or bottom knockout as desired. Remove the
screw inside the dryer exhaust duct and save. Pull
the duct out of the dryer.
Fixing hole
\
', A
i
i
L .................... _
I_ 9-1/2" (24.13cm)_I
For models GTD60, GTD65 and GTD68 only, use the
dimension below.
Fixing hole
Cut the duct as shown and keep portion A.
15
TAB LOCATION
BENDTAB
UP45°
gas
Through the rear opening, locate the tab in the
middle of the appliance base. Lift the tab to about
45 °, using a flat-blade screwdriver.
ADDING A NEW DUCT
Fixing hole Portion "A)'
Right(electric _,,1[ > k]<"i ';" "_ "y ,;,;-_/ i ,,/
models
only)or
_
I:_ `)'y-
left side exhaust -.._._:_ _
Reconnect the cut portion (A) of the duct to the
blower housing. Make sure that the shortened
duct is aligned with the tab in the base. Use the
screw saved previously to secure the duct in place
through the tab on the appliance bose.
ADDING ELBOW AND DUCT FOR EXHAUST TO
SIDE OF CABINET
Rig.h ./ _
Exhaust can_ _;'Z _J'_
be added to _---__
right (electric _ _ _'r_,,_,
models only) "_ Left ....
or left side t__"__ tape
= i,):
Left
• Preassemble 4" elbow with 4" duct. Wrap duct
tape around joint.
• Insert duct assembly, elbow first, through the
side opening and connect the elbow to the dryer
internal duct.
Be sure not to pull or damage the electrical wires
inside the dryer when inserting the duct,