Disposing Of Com600 - ABB COM600 series User Manual

1MRS756125
4.5.
COM600 series, version 4.1
User's Manual
3. Select Integrated Peripherals from the main SETUP menu. Use the cursor keys
for moving and enter key for selection.
4. Select SuperIO Device from the next menu.
5. On the SuperIO Device configuration page, go to the COM2 Select parameter
and press ENTER. Now you can choose between RS-232 and RS-485.
6. Press the F10 key to save the changes and exit the BIOS setup.
Pinout of COM2 port when RS-485 mode is used:
DB9 connector:
1. TX-/RX-
2. N/A
3. TX+/RX+
4. N/A
5. GND
6. N/A
7. N/A
8. N/A
9. N/A

Disposing of COM600

Definitions and regulations of hazardous materials are country-specific and change when
the knowledge of materials increases. The materials used in this product are typical for
electric and electronic devices.
All parts used in this product are recyclable. When disposing of cast-off COM600 or its
parts, contact the local entrepreneurs who are authorized and specialized in handling
electrical/electronic waste. These partners can sort the material by using dedicated sorting
processes and dispose of the product according to the local requirements.
Table 4.5-1 Materials of COM600 parts
COM600
Case
Modules
Package
Attached material
Part
Top cover, heat sink
Other covers, screws
Plastic parts
Compact flash disk
Modules inside the case
Battery
Box
Accessory kit
DVD
Material
Aluminium
Steel (SECC)
PC 2 , PP 3
Various
Various
Lithium
Cardboard
Steel (SECC), PBT 1
PC 2 , PP 3
37