Download Print this page
OHAUS Ranger 7000 Quick Start Manual
OHAUS Ranger 7000 Quick Start Manual

OHAUS Ranger 7000 Quick Start Manual

Hide thumbs Also See for Ranger 7000:

Advertisement

Quick Start Guide
Safety Precautions
Caution: Read all safety warnings before installing, making connections, or servicing this
equipment. Failure to comply with these warnings could result in personal injury and/or
property damage. Retain all instructions for future reference.
Verify that the input voltage range printed on the data label and the plug type matches the local AC
power to be used.
Only connect models supplied with a grounded power cord to a compatible grounded power
receptacle.
Do not position the scale such that it is difficult to disconnect the power cord from the power
receptacle.
Make sure that the power cord does not pose a potential obstacle or tripping hazard.
This scale is for indoor use only.
Use the scale in dry locations only.
Do not drop loads on the pan.
Use only approved accessories and peripherals.
Operate the equipment only under ambient conditions specified in these instructions.
Disconnect the equipment from the power supply when cleaning.
Do not operate the equipment in hazardous or unstable environments.
Service should only be performed by authorized personnel.
Installation
Unpacking
Carefully remove your Ranger 7000 scale and each of its components from the package. The included
components vary depending on the scale model (see table below). Save the packaging to ensure safe storage
and transport.
Included Component
Terminal
Weighing
Base
Weighing
200 x 200 mm
Platform
Weighing
240 x 240 mm
Platform
Weighing
311 x 371 mm
Platform
Wind Shield
Compact
Instruction
Disc
Manual
Ohaus Corporation www.ohaus.com
R71MHD3
Photo
R71MHD6
X
X
X
X
X
iii
Ranger
7000
R71MD3
R71MHD15
R71MD6
R71MHD35
X
X
X
X
X
X
X
X
Ranger 7000 Quick Start Guide
R71MD15
R71MD35
R71MD60
X
X
X
X

Advertisement

loading

Summary of Contents for OHAUS Ranger 7000

  • Page 1 Service should only be performed by authorized personnel. Installation Unpacking Carefully remove your Ranger 7000 scale and each of its components from the package. The included components vary depending on the scale model (see table below). Save the packaging to ensure safe storage and transport.
  • Page 2 Connecting Power and Turning ON the Scale The Ranger 7000 comes with an AC power cord. Connect the power cord to a suitable grounded electrical outlet and press the ON button on the side of the base (see figure below).
  • Page 3 To Enter ‘_’ press 3 times. Perform Zero operation Perform Tare operation When entering the value first and then pressing this button the number input will be set to preset Tare value. Ohaus Corporation www.ohaus.com Ranger 7000 Quick Start Guide...
  • Page 4 Equipment (WEEE) this device may not be disposed of in domestic waste. This also applies to countries outside the EU, per their specific requirements. Ohaus® and Ranger® are either registered trademarks or trademarks of Ohaus Corporation in the United States and/or other countries.