Advertisement
Installation:
1. Select the location where the sensor will be mounted.
2. The sensor should be mounted 6~9ft (2~3m) above the ground, have a
clear view of the desired detection area, and be safe from water.
3. Use the two included mounting screws to mount the sensor bracket to
the surface.
4. Slide the sensor down onto the bracket.
5. Point the sensor toward the desired detection area.
Programming the Sensor:
Removing the Cover
1. To access the timer programming and install/change the battery, the cover of the sensor
must be removed.
Note: Remove the sensor from the bracket before removing the cover.
2. Push down behind the tab on the top of the sensor and carefully pull the cover away from
the sensor body.
Programming the Sleep Timer
1. Use the DIP Switch to program the sleep timer to 5 seconds or 5 minutes. The sensor will
not reactivate for the set amount of time after the sensor is triggered.
5 Minutes
*Default setting
Pairing the Sensor:
1. Follow the pairing instructions for the RA-4961-K1Q receiver or RA-4961-VPQ wireless
receiver to enter the pairing mode. (Refer to the RA-4961-K1Q or RA-4961-VPQ manual for
detailed instructions).
2. Turn the sensor on and wait up to 15 seconds for the PIR to begin sensing.
3. Wave a hand in front of the sensor to activate it for pairing.
4. The receiver will beep once and cycle to the next channel
to confirm successful pairing.
SECO-LARM U.S.A., Inc.
5 Seconds*
CBA Wireless Indoor PIR sensor
6~9'
(2~3m)
3
Advertisement
