Attaching The Power Cord - AT&T Unix PC Hardware Installation Manual

Installing Hardware

Attaching the Power Cord

Turn the
1
easily see the rear of the main unit.
Check to make sure the Power Switch is in the
"O"
3 Plug the black power cord firmly into its
receptacle located in the back of the
workstation.
Plug the power cord directly into a three-hole
grounded wall socket.
The following illustration shows the location of the
Printer port and the
to these ports must be shielded cables.
�--­
�--­
�--­
���­
��-­
---­
�--�
12
UNIX PC around enough so you can
(OFF) position.
RS-232
Printer Port
Power Switch
Power Cord Receptacle
ports. Any cables attaChed
��
�-�­
��­
��
��
��
��
RS-232 Port