Ce Mark Warning; Rf Exposure Information; National Restrictions - TP-Link Archer C5400 User Manual

For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.

RF Exposure Information

This device meets the EU requirements (1999/519/EC) on the limitation of exposure of
the general public to electromagnetic fields by way of health protection.
The device complies with RF specifications when the device used at 20 cm from your
body.

National Restrictions

This device is intended for home and office use in all EU countries (and other countries
following the EU directive 1999/5/EC) without any limitation except for the countries
mentioned below:
Country Restriction
Belarus Not implemented
Norway
Implemented
Implemented
Italy
Limited
Russian
implementation
Federation
Limited
Ukraine
implementation
ATTENTION: Due to EU law, the country settings must be identical to the country where
the device is operating (important due to non-harmonised frequencies in the EU).
This subsection does not apply for the geographical area within a radius of 20
km from the centre of Ny-Ålesund on Svalbard.
The public use is subject to general authorisation by the respective service
provider.
1. SRD with FHSS modulation
1.1. Maximum 2.5 mW e.i.r.p.
1.2. Maximum 100 mW e.i.r.p. Permitted for use SRD for outdoor applications
without restriction on installation height only for purposes of gathering
telemetry information for automated monitoring and resources accounting
systems. Permitted to use SRD for other purposes for outdoor applications only
when the installation height is not exceeding 10 m above the ground surface.
1.3.Maximum 100 mW e.i.r.p. Indoor applications.
2. SRD with DSSS and other than FHSS wideband modulation
2.1. Maximum mean e.i.r.p. density is 2 mW/MHz. Maximum 100 mW e.i.r.p.
2.2. Maximum mean e.i.r.p. density is 20 mW/MHz. Maximum 100 mW e.i.r.p. It
is permitted to use SRD for outdoor applications only for purposes of gathering
telemetry information for automated monitoring and resources accounting
systems or security systems.
2.3. Maximum mean e.i.r.p. density is 10 mW/MHz. Maximum 100 mW e.i.r.p.
Indoor applications.
e.i.r.p. ≤100 mW with built-in antenna with amplification factor up to 6 dBi.
Reason/remark
112