Perform Stunts - Radio Shack Zeraxa 6001352 User Manual

Calibrate
When flying in a new location, or when controlling the drone
becomes difficult, use the following steps to calibrate the compass.
Regular calibration keeps the compass finely tuned.
1. Select an open location without strong magnetic interference and
place the drone and remote control on level ground.
2. Turn on the drone and switch the remote control to Special.
Then pair the remote control with the drone.
3. Calibrate the drone:
a. Hold down the throttle and steering
backward at the same time until the two
LEDs on the top of the body flash quickly.
b. Rotate the drone by hand 2–4 times.
c. Hold the drone vertically, and rotate it until the body LEDs
flash slowly.
6001352_UG_EN_030315.indd 12-13
12
4. Calibrate the remote control:
a. Move and hold the throttle and steering inward 45 degrees at
the same time until the control's LED flashes quickly.
emote control 3–5
b. Rotate the r
flashing and lights steadily, calibration is complete.
Note: After calibration, turn off the drone and remote control, and
then turn on the drone and switch the remote control to Special.

Perform Stunts

1. Press FLIP. The remote control beeps.
2. Move the steering to perform stunts:
• Front flip: Move lever forward
• Back flip: Move lever backward
• Barrel roll: Move lever right/left
3. To exit stunt mode, press FLIP again before moving the steering.
IMPORTANT: Make sure there is enough space for the drone to
perform stunts without crashing into objects or people.
imes
t . When the LED stops
13
3/3/2015 2:52:40 PM