Installation - JVC DT-V21G2 Instructions Manual

Installation

Do not rest your arm on the monitor or lean against the monitor.
l
Do not touch the LCD panel when installing the monitor.
l
Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.
l
How to set up 1
l
You can tilt the monitor as follows.
Monitor
Approx. 6°
0°
Approx. 6°
Be careful not to pinch your fingers in the gap between the
l
monitor and the stand.
How to set up 2
l
You can place the monitor as illustrated below.
1
Remove the screws on the sides of the stand (see the following
illustration), and lift up the stand.
Screw (silver)
* Approx. 148° for DT-V24G2.
1
2
Attach the removed screws and place the monitor as illustrated
below.
To place the monitor as shown in "How to set up 1" again, remove
l
the screws on the sides of the stand, align the guidelines, and then
reattach the screws.
CAUTION
When lifting up the stand...
l
- Lay the monitor on a cloth with the LCD panel facing down to
prevent the LCD panel from being damaged.
- Be careful not to pinch your fingers in the moving parts.
Make sure to lift the stand up so that the monitor will be
l
vertical; otherwise the monitor may fall over.
Place the monitor on a mat to avoid scratching the table
l
surface.
4 4
When the monitor is not tilted (0°),
the guidelines align as illustrated
below.
Guidelines
Stand
The illustration of the
monitor is of DT-V21G2.
Approx.
141° *
1
The illustration of the
monitor is of DT-V21G2.
To detach the stand
l
Lay the monitor on a cloth with the LCD panel facing down to
prevent the LCD panel from being damaged.
Attachment screws
Screw holes for stand
attachment
Monitor
To install the stand
l
When attaching the stand to the monitor, insert the guides of
the stand plate into the guide holes on the monitor to place the
stand in the correct position. Then fix the stand firmly with the
attachment screws.
Guide holes
Guides
Stand plate
Stand body
Stand body
The illustration of the
monitor is of DT-V21G2.
Monitor
Screw holes for
stand attachment
The illustration of the
monitor is of DT-V21G2.