Table of Contents
Advertisement
3.4 Connecting the Display
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC plug to the power connector on the monitor and the other end
into an electrical outlet.
3. Connect the D-SUB or DVI cable from the display's D-SUB or DVI input connector
to the D-SUB or DVI connector of your host computer and tighten the screws.
4. Connect the USB cable from the USB port of your display to the USB port of your
computer.
5. Configure the touch screen. Refer to the "Touch Screen Driver Installation" section
on page 21.
6. Once the touch screen is configured, the monitor is ready for use.
To ensure the LCD display works well with your computer, please
configure the display mode of your graphics card to make it less than or
equal to 1920 x 1080 resolution and make sure the timing of the display
mode is compatible with the LCD display.
We have listed the compatible "Video Modes" of your LCD display in the
appendix (on page 16) for your reference
External power supplies applicable: Lite-On/PA-1051-0
Photo_6 – Connecting view
11
Advertisement
Table of Contents
