Setting Up The Camera (Initial Setup) - Panasonic KX-HNC800 Installation Manual

Setting up the
camera (initial
setup)
Confirm the following before you
begin.
– Make sure you have installed
the [Home Network] app on
your mobile device
– Make sure the camera is
located within range of your
wireless router
– Make sure your mobile device
is connected to your wireless
router
– Make sure your mobile device
can connect to the Internet
– Make sure you know the
network name (SSID) and
password assigned to your
wireless router
For assistance, please visit http://shop.panasonic.com/support
HNC800_(en_en)_0902_ver.220.pdf 19
Initial setup (for iPhone, iPad
users)
R Do not perform this procedure
if you want to integrate the
camera with your Home
Network System. Use the
procedure on page 24.
R If your mobile device is
already registered to a hub
and you want to use your
camera by itself, see
"Information for current hub
users", page 22.
1
Plug in the camera and wait
about 1 minute for the
camera's LED to light in green.
R If the LED does not light in
green, or if you experience
trouble during this
procedure, reset the
camera (page 25) and
then repeat this procedure.
2
Start the [Home Network]
app.
R If prompted, follow the
on-screen instructions and
select the appropriate
region/country.
3
Tap [HD Camera].
4
Tap [Set up the HD Camera].
5
When prompted, press the
MSETUPN button on the back
Setup
19
2016/09/05 17:54:31