Initial Setup; General Operation - Alba VL19HDLED-D Instruction Manual

Getting to know your TV
You'll be up and running in no time

Initial setup

1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to the RF
(75 ) socket at the bottom of your TV.
2. Connect the mains cable to the mains socket after you
have completed all the connections.
3. With power cord plug connected to the mains power
socket and TV in 'Standby' mode.At this stage, the TV
switches to standby mode. The red LED indicator will
illuminate on the front panel of the TV.
4. In standby mode, press the " " button on the right of the
TV or the " " button on the remote control to turn the TV
on. The red LED indicator will turn blue.
5. The first time you turn the TV on, it will go straight
into First Time Setup menu. Press the
navigate the menu and change the settings.
First Time Setup
OSD Language
Mode Setting
Country
Tuner Type
Auto Scan
LCN
Auto Channel Update
Start
Move Adjust
OSD Language
Selects your desired language to be displayed on the menu.
The default on-screen menu language is set as English.
Mode Setting
Selects your desired mode setting.
home mode.
Country
Selects the country where you will operate the TV. The
default country is set as UK.
Tuner Type
Select Tuner Type: Cable / Antenna.
Auto Scan
Selects the auto scan type: DTV+ATV / DTV /ATV.
LCN
Select LCN Type On or Off.
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105.
buttons to
English
Home Mode
UK
Cable
DTV+ATV
Off
Off
MENU: Return EXIT: Exit
Auto Channel Update
Select Auto Channel Update Type On or Off.
Start
Press the OK button to start auto tuning. Auto Scan will
commence. The display will show the progress of the
tuning and the number of channels found.
Auto Scan
Scanning CH34
Digital Channels Found:
DTV :10 Radio :0 Data:0
Analog Channels Found: 0
6. If you want to skip the DTV tuning, press the TV.MENU
button to interrupt the tuning half way. You will then go
straight to ATV tuning. You may repeat the above step if you
also want to skip the ATV tuning.

General operation

Press the INPUT button on the remote control and select
DTV to switch the TV to Digital Terrestrial Television
Broadcasting.
Information Banner
Whenever you change channel using the CH+/CH- buttons
or the number buttons, the TV displays the broadcast
picture along with an information banner on the top left of
the screen (available only in DTV/ATV mode).
The information banner can be displayed a any time while
watching TV by pressing the INFO button on the remote
control.
MENU: Skip EXIT: Exit
21