Makita DVC860L Instruction Manual page 11

not allowed to install powder filter solely.
Installing the water filter
(for cloth filter model) (optional accessory)
CAUTION:
Never pick up water or wet dust without the float
•
and the cloth filter or the water filter.
For picking up wet dust, make sure that the float
•
cage and the float are installed on the cleaner.
When installing the water filter on the tank, set it tight
•
at the opening of the tank so that the hook of the
water filter engages the tank opening firmly and there
is no space between the water filter and the tank.
NOTICE:
It is recommended using water filter when picking
•
up large amount of water repeatedly. Otherwise
vacuum ability may be reduced in case of cloth filter.
Fig.11
To pick up water or wet dust only, the water filter is more
suitable than the cloth filter.
When installing the water filter, align its mounting
position mark with the one on the tank.
Installing the paper pack (optional accessory)
WARNING:
When using the paper pack, also use the cloth
•
filter or prefilter together that is preinstalled on the
tool. Failure to use the cloth filter / prefilter
together may cause unusual noise and heat,
resulting in a fire.
CAUTION:
(For the cloth filter model)
Never pick up water or other liquids or wet dusts
•
when using the paper pack. Picking up such things
may cause the paper pack breakage.
Before using the paper pack, make sure that
•
powder filter (optional accessory), damper (optional
accessory) and prefilter are always used together.
(For the powder filter model)
Before using the paper pack, make sure that
•
powder filter, damper and prefilter are always used
together.
1. Remove the rubber holder.
Fig.12
2. Extend the paper pack.
3. Align the paper pack opening with the dust
suction opening of the cleaner.
4. Insert the cardboard of the paper pack onto the
holder so that it is positioned at the end beyond
the detent protrusion.
Fig.13
Installing the polyethylene bag
Cleaner can also be used without polyethylene bag.
However, using polyethylene bag is easier to empty the
tank without letting your hands dirty.
1. Holder plate
2. Polyethylene bag
015542
Spread the polyethylene bag in the tank. Insert it between
the holder plate and the tank, and pull it to the hose inlet.
Spread the bag around the top of the tank so that the
prefilter edge can catch and hold the bag securely.
NOTE:
A polyethylene bag available on the market can be
•
used. 0.04 mm or thicker one is recommended.
Too much dust will tear the bag easily, so do not
•
collect the dust more than the half of the bag capacity.
Emptying the polyethylene bag
WARNING:
Always make sure that the cleaner is switched off
•
and unplugged before emptying the polyethylene
bag. Failure to do so may cause an electric shock
and serious personal injury.
CAUTION:
Do not apply a great impact on the float cage and
•
tank. Applying a great impact may cause
deformation and damage to the parts.
Empty the tank at least once a day although this
•
depends on picked-up dust volume in the tank. Or, the
suction force will weaken and the motor may be broken.
Do not grab the hook when emptying the tank.
•
Grabbing the hook may cause the hook to break.
Unhook and lift up the tank cover.
Fig.14
Shake off the dust from the cloth filter / powder filter and
then take the polyethylene bag out of the tank.
NOTE:
Take the polyethylene bag carefully out of the tank so
•
that the polyethylene bag cannot be caught and torn
by the protrusion inside the tank when emptying it.
Empty the polyethylene bag before it becomes full.
•
Too much dust in the tank may cause the
polyethylene bag to be torn.
11
1
2