Spinshot Player User Manual page 6

STOP: The button will trigger the machine to stop. This process will
only halt the feeding of the ball but not the running of central service
motors. If a user wants to turn off the whole machine, it is required to
use the POWER button. User is not required to STOP the machine
when switching between the different drill modes.
DRILL: This includes the 12 buttons from D1 to D12. Pressing these
buttons will make the machine work in different drill modes. All drill
mode settings can be edited on your mobile phone and then
downloaded to your machine and be ready for use. Please find more
details in the section referred to as "Phone Remote"
Battery Charging (for Battery Model)
You will need to first connect the battery charger to a live electrical
outlet and then insert the battery charger into the socket labeled as
"CHARGER" on the control panel.
After 8 to 15 hours your battery is fully charged. The LED light on the
charger pack will turn green when the machine is fully charged. If LED
light stays red, the charging process is still continuing. A fully charged
battery will provide approximately 2-3 hours of practice time. Higher
ball speed requires more power and therefore will drain the battery
faster.
It is very important to CHARGE THE BATTERY IMMEDIATELY
AFTER EACH USE. Keeping the charger connected to the machine
will not overcharge the battery and the users don't need to use up the
battery before charging it.
Battery Cage
The battery cage enables the user to
easily install and replace the battery
or an AC module. Remove the wheel
first before opening the battery cage
door. If a wheel was installed too
tight, screw it down. After opening the